There are two types of multiplication that can be done with vectors: = +.

Similar documents
Vector Supplement Part 1: Vectors

Math 370 Exam 3 Review Name

The polar coordinates of a point are given. Find the rectangular coordinates of the point. 1) 7, 2 3 D) - 7 2, A) - 7 2, 7 3

1 Vectors. c Kun Wang. Math 151, Fall Vector Supplement

SUPPLEMENT I. Example. Graph the vector 4, 3. Definition. Given two points A(x 1, y 1 ) and B(x 2, y 2 ), the vector represented by # AB is # AB =,

Vectors are used to represent quantities such as force and velocity which have both. and. The magnitude of a vector corresponds to its.

Math 370 Exam 3 Review Name

12.1 Three Dimensional Coordinate Systems (Review) Equation of a sphere

SHORT ANSWER. Write the word or phrase that best completes each statement or answers the question.

Math 1316 Exam 3. if u = 4, c. ÄuÄ = isin π Ë 5 34, , 5 34, 3

Vectors. 1 Basic Definitions. Liming Pang

Unit #17: Spring Trig Unit. A. First Quadrant Notice how the x-values decrease by while the y-values increase by that same amount.

Definition (Polar Coordinates) Figure: The polar coordinates (r, )ofapointp

MATH 151 Engineering Mathematics I

Introduction. Law of Sines. Introduction. Introduction. Example 2. Example 1 11/18/2014. Precalculus 6.1

Test # 3 Review Math Name (6.5 to 6.7, 10.1 to 10.3,and 10.5)

7.3. Applications of the Dot Product. Solution. Find the Angle Between Two Vectors. Solution

9.4 Polar Coordinates

DOT PRODUCT Objective:

Chapter 1E - Complex Numbers

PreCalculus Notes. MAT 129 Chapter 10: Polar Coordinates; Vectors. David J. Gisch. Department of Mathematics Des Moines Area Community College

6.4 Vectors and Dot Products

EQUATIONS OF MOTION: RECTANGULAR COORDINATES

Exercise. Exercise 1.1. MA112 Section : Prepared by Dr.Archara Pacheenburawana 1

Chapter 7.4: Vectors

10.2,3,4. Vectors in 3D, Dot products and Cross Products

Math 2412 Pre Calculus TEST 2 Prep Fall 2011

When two letters name a vector, the first indicates the and the second indicates the of the vector.

27 ft 3 adequately describes the volume of a cube with side 3. ft F adequately describes the temperature of a person.

Review of Coordinate Systems

Vectors. Examples of vectors include: displacement, velocity, acceleration, and force. Examples of scalars include: distance, speed, time, and volume.

8-3 Dot Products and Vector Projections

Name Period Date. 75 kg. Horizontal, frictionless surface. Label a coordinate system, write the formula, substitute and solve.

1. Find the Dot Product of Two Vectors 2. Find the Angle Between Two Vectors

NEWTON S LAWS OF MOTION (EQUATION OF MOTION) (Sections )

Mathematical review trigonometry vectors Motion in one dimension

OpenStax-CNX module: m Vectors. OpenStax College. Abstract

Linear Algebra V = T = ( 4 3 ).

SECTION 6.3: VECTORS IN THE PLANE

ACTM Regional Math Contest Pre-Calculus/Trigonometry 2010

Three-Dimensional Coordinate Systems. Three-Dimensional Coordinate Systems. Three-Dimensional Coordinate Systems. Three-Dimensional Coordinate Systems

Vectors are used to represent quantities such as force and velocity which have both. and. The magnitude of a vector corresponds to its.

MATH 1020 WORKSHEET 12.1 & 12.2 Vectors in the Plane

12.3 Dot Products, 12.4 Cross Products

Bonus Section II: Solving Trigonometric Equations

10.1 Vectors. c Kun Wang. Math 150, Fall 2017

February 26, Algebraic Method (filled).notebook PHYSICS 11 TEACHER'S NOTES LESSON

APPLICATIONS OF INTEGRATION

Forces and Newton s Laws Notes

The choice of origin, axes, and length is completely arbitrary.

10.1 Curves Defined by Parametric Equation

Torque. Objectives. Assessment. Assessment. Equations. Physics terms 6/2/14

9.1 VECTORS. A Geometric View of Vectors LEARNING OBJECTIVES. = a, b

Monday Tuesday Block Friday 13 22/ End of 9-wks Pep-Rally Operations Vectors Two Vectors

Trigonometry Test 3 Practice Chapters 5 and 6 NON-CALCULATOR PORTION

4.4 Energy in multiple dimensions, dot product

BELLWORK feet

3. Interpret the graph of x = 1 in the contexts of (a) a number line (b) 2-space (c) 3-space

Physics Chapter 4 Newton s Laws of Motion

1)Write the integer that represents the opposite of each real-world. situation. In words, write the meaning of the opposite.

Chapter 6. Additional Topics in Trigonometry. 6.6 Vectors. Copyright 2014, 2010, 2007 Pearson Education, Inc.

11.8 Vectors Applications of Trigonometry

BC VECTOR PROBLEMS. 13. Find the area of the parallelogram having AB and AC as adjacent sides: A(2,1,3), B(1,4,2), C( 3,2,7) 14.

Teacher Content Brief

F F. proj cos( ) v. v proj v

MATH 12 CLASS 2 NOTES, SEP Contents. 2. Dot product: determining the angle between two vectors 2

MAT 1339-S14 Class 8

DATE: MATH ANALYSIS 2 CHAPTER 12: VECTORS & DETERMINANTS

Chapter 4 Newton s Laws

Unit 11: Vectors in the Plane

Student Content Brief Advanced Level

Precalculus Notes: Unit 6 Vectors, Parametrics, Polars, & Complex Numbers

9.1 VECTORS. A Geometric View of Vectors LEARNING OBJECTIVES. = a, b

POGIL: Newton s First Law of Motion and Statics. Part 1: Net Force Model: Read the following carefully and study the diagrams that follow.

Vectors and the Geometry of Space

POSITION VECTORS & FORCE VECTORS

4.2. Visualize: Assess: Note that the climber does not touch the sides of the crevasse so there are no forces from the crevasse walls.

Solving two-body problems with Newton s Second Law. Example Static and Kinetic Friction. Section 5.1 Friction 10/15/13

EQUIVALENT SYSTEMS, RESULTANTS OF FORCE AND COUPLE SYSTEM, & FURTHER REDUCTION OF A FORCE AND COUPLE SYSTEM

Applying Newton s Laws

TMTA Calculus and Advanced Topics Test 2010

AP/Honors Physics Take-Home Exam 1

4.3 TRIGONOMETRY EXTENDED: THE CIRCULAR FUNCTIONS

1. A sphere with a radius of 1.7 cm has a volume of: A) m 3 B) m 3 C) m 3 D) 0.11 m 3 E) 21 m 3

Pre-Calculus Final Exam Review Name: May June Use the following schedule to complete the final exam review.

Math 1316 t4rsu14. Name: 06/24/2014

Chapter P. Prerequisites. Slide P- 1. Copyright 2007 Pearson Education, Inc. Publishing as Pearson Addison-Wesley

Precalculus Notes: Unit 6 Vectors, Parametrics, Polars, & Complex Numbers. A: Initial Point (start); B: Terminal Point (end) : ( ) ( )

SHORT ANSWER. Write the word or phrase that best completes each statement or answers the question.

1. The horizontal beam represented in Examination Figure 6 carries three loads P 1. and R 2

15. LECTURE 15. I can calculate the dot product of two vectors and interpret its meaning. I can find the projection of one vector onto another one.

Lecture III. Introduction to Mechanics, Heat, and Sound /FIC 318

Chapter 5. The Laws of Motion

Pre-Calculus Vectors

Chapter 3 Vectors Prof. Raymond Lee, revised

Chapter 8: Polar Coordinates and Vectors

Mathematics 5 SN Guide

Newton s Laws of Motion

Chapter 4. Table of Contents. Section 1 Changes in Motion. Section 2 Newton's First Law. Section 3 Newton's Second and Third Laws

Forces of Friction Contact between bodies with a relative velocity produces friction opposite

Transcription:

Section 7.5: The Dot Product Multiplying Two Vectors using the Dot Product There are two types of multiplication that can be done with vectors: Scalar Multiplication Dot Product The Dot Product of two vectors =, and =, is given by =+. Note that and need to be the same size of vector and the result of the dot product is a scalar. Example 1: Finding the Dot Product of Two Vectors Find the dot product of 1,2 3,4. Properties of the Dot Product 1. = 2. = 3. =0 4. = = 5. + = + 6. += +

How could we find the angle between two vectors? If is the angle, 0 180, between two nonzero vectors and, then = Example 2: Finding the Angle Between Two Vectors Find the smaller angle between 2, 1 and 1,3. When two vectors are parallel, the angle between them is When two vectors are perpendicular, the angle between them is Suppose two non-zero vectors are perpendicular, meaning that 90 = Then:

Orthogonal Vectors Two vectors and are orthogonal (perpendicular) if and only if their dot product is zero. Example 3: Determining Whether Vectors are Orthogonal Determine whether each pair of vectors is an orthogonal pair. a. = 6,8 and = 8, 6 b. = 6, 4 and = 6, 9 Work! Work is done when a force causes an object to move a certain distance. Simplest case: When force is going in the same direction as the displacement - Think a stagecoach with horses, the horses pull with a force in the same direction. In this case, =, or the magnitude of force over a distance,, and this would result in being a scalar.

However, life is cruel, and often times force will not be in same direction as displacement, so more often than not, we ll need more than just the magnitude of the vector. Suppose my truck ran out of gas and I m stuck having to push it to the nearest gas station. Part of the force, that I m using to push my truck is going towards forward, horizontal motion, or. Suppose I let be the angle between these two force vectors. Then I could solve for =. Wee little example: If I push on my truck with 150 pounds of force with an angle of 30, the horizontal component of the force vector is This means that our equation for work from earlier would be in general = = Where d is the displacement vector and F is the force vector.

Example 4: Calculating Work How much work is done when a force (in pounds) = 2,4 moves an object from 0,0 to 5,9 (where distance is in feet). Example 5 (#50) To slide a crate across the floor, a force of 800 lbs at a 20 angle is needed. How much work is done if the crate is dragged 50 feet? Round to the nearest ft-lb.

Chapter 8 Section 8.4: Polar Equations and Graphs Polar Coordinates The Polar Coordinate System is centered around the pole, which corresponds to the origin on the Cartesian Plane. Additionally, there is the polar axis which is a ray with its endpoint at the pole. Angles are then labeled around the entire graph either in radians or degrees. How to plot polar coordinates: To plot the point,: 1. Start on the polar axis and rotate the terminal side of the angle to the value. 2. If >0, the point is units from the origin in the same direction of the terminal side of. 3. If <0, the point is units from the origin in the opposite direction of the terminal side of.

Example 1: Plotting Points in the Polar Coordinate System Plot the following points in the polar coordinate system. a. 3, ) b. 2,60 Converting Between Polar and Rectangular Coordinates From To Identities Polar, Rectangular, = and = Rectangular, Polar, = + and =,0

Example 2: Converting Between Polar and Rectangular Coordinates a. Convert the rectangular coordinate 1, 3 to polar coordinates. b. Convert the polar coordinate 3 3,75 to rectangular coordinates. Graphs of Polar Equations Not only do we have graphs of equations on the coordinate plane, but there are also (pretty!) graphs of polar equations. Example 3: Graphing a Polar Equation of the Form = or = Graph the polar equations a. =3 b. =

Example 4: Graphing a Polar Equation of the Form = or = Graph =4. =4, 0 4 2 3 4 5 4 3 2 7 4 2

Example 5: Graphing a Polar Equation of the Form cos2 or sin 2 Graph 5sin2 5sin 2, 0 8 4 3 8 2 Let s use our calculators to graph the following: Example 6: The Cardioid as a Polar Equation Graph 22 Example 7: Graphing a Polar Equation of the Form Graph /2

In some cases, plotting an equation in the form that it is given in is not convenient. For example, plotting than the same equation in rectangular form. Example 8: Graph. is much more complicated