Application Note 3 Fast Protein and Peptide Separations Using Monolithic Nanocolumns and Capillary Columns INTRODUCTION Polymeric monolithic stationary phases offer an alternative to the classical microparticulate sorbents, bringing important advantages to sample analysis. In contrast to the traditional stationary phases that consist of packed particles, the monolithic separation medium is made of a continuous, rigid polymeric rod with a porous structure. The lack of intraparticular void volume improves mass transfer and separation efficiency, which allows for very fast separations of biopolymers., INSTRUMENTATION All experiments were performed on the UltiMate Plus Nano and Capillary LC System equipped with a special 3-nL UV flow cell, and the FAMOS Micro Autosampler. The Monolithic nanocolumn (-µm i.d. cm) or capillary column (-µm i.d. cm), consisting of PS-DVB (polystyrene-divinylbenzene polymer), was thermostatted at C, using the UltiMate column oven. UV detection was performed at nm, and the flow rate was either µl/min (-µm i.d.) or. µl/min (-µm i.d.). For LC-MS, the system was coupled online to the esquire3 plus (Bruker Daltonics). HIGH-RESOLUTION PROTEIN AND PEPTIDE SEPARATIONS Figure shows the separation of a tryptic digest of cytochrome c on a -µm i.d. Monolithic LC nanocolumn. A gradient from -% acetonitrile in acidified water (.% TFA) is performed in 8 min, resulting in a fast separation of each peptide with baseline resolution. Figure. Monolithic column in protective housing. Application Note 3
.88 8 3 7. 7 8 9 Figure 3 shows the separation of a test mixture consisting of nine peptides on a -µm i.d. Monolithic capillary column. A gradient from % acetonitrile in water,.% trifluoroacetic acid (TFA) is performed in 7 min, resulting in a fast baseline separation of all peptides. Peak widths at half height (PWHH) of only. 3. s illustrate the fast separations that are achievable using a Monolithic capillary column (see Table ). Under isocratic conditions, efficiencies up to, plates/m are achieved. Figure. Nano LC separation of cytochrome c sample (8 fmol/µl). Injected amount.3 µl. Table. Peak Width at Half Height (PWHH) for Peptides Separated on a Monolithic Capillary Column Peptide Retention Time PWHH min s. Bradykinin fragment 3.3 3.. Vasopressin [Arg 8 ] 3.8. 3. Methionine enkephalin..9 Peaks:. Bradykinin fragments,. Vasopressin [Arg 8 ] 3. Methionine enkephalin. Leucine enkephalin. Oxytocin. Bradykinin 7. LHRH 8 Bombesin 9. Substance P Injected amount: fmol each Detection: UV nm, response time. sec. 3 7. Leucine enkephalin..3. Oxytocin... Bradykinin.9. 8 9 7. LHRH..9 8. Bombesin.3. 9. Substance P.. 7 Figure 3. Separation of a peptide test mixture. Fast Protein and Peptide Separations Using Monolithic Capillary Columns and Nanocolumns
8. 3 Peaks:. Ribonuclease. Lysozym 3. α-lactalbumin. Myoglobin. Ovalbumin Injected amount: fmol each TFA VS FORMIC ACID For highly sensitive LC-MS applications using nanoelectrospray, weaker acids such as formic acid (FA) are often preferred over the stronger TFA as mobile phase additives to reduce the discrimination effect. Figure shows a comparison using both additives for the separation of the same peptide test mixture. Independent of the mobile phase additive (i.e., TFA or formic acid), excellent separations are obtained. Using formic acid as an ion pair, PWHH increased only marginally and the peak height decreased by only 3%.. 8 Figure. Separation of proteins. FA Aside from the analysis of peptides, polypeptides, and protein digests, interest is increasing in proteomics for the analysis of intact proteins. Therefore, the same -µm i.d. Monolithic capillary columns have been evaluated for the separation of protein mixtures. Figure shows the separation of a protein mixture using a gradient of % acetonitrile in water,.% TFA, in min. Similar separation efficiencies are achieved for the peptides, illustrating the excellent performance of Monolithic columns for both peptides and proteins. Figure shows a closeup of the chromatogram of peaks 3 and, illustrating symmetrical peak shapes and PWHHs of only a few seconds. Figure. Separation of peptide test mixture (peptides 9, see Figure ) on a Monolithic capillary column with.% formic acid (FA) and.% TFA as mobile phase additives. TFA. 8 3 3. s. 7. 7.7 7.9 8. 8.3 8. 9 Figure. Closeup of the separation of proteins 3 and. Application Note 3 3
ON-LINE COUPLING TO ESI-MS To illustrate the use of Monolithic capillary columns in LC/MS, Figure 7 shows the separation of a protein digest mixture. The mixture consists of cytochrome c, lysozyme, alcohol dehydrogenase, BSA, apotransferrin, and ß-galactosidase with a molecular weight ranging from to 3 kda and digested with trypsin. The gradient consists of (A).% formic acid, and (B) 8% acetonitrile,.8% formic acid, from to % B in min. Figure A shows the base peak chromatogram (BPC), illustrating the high peak capacity of the Monolithic column for the separation of complex samples. Figure B shows a closeup of the BPC between. and 8. min with two minor tryptic peptides eluting at 7. 7. min. From the tryptic peptide eluting at 7. min, the MS-MS spectrum is shown in Figure C with the corresponding Mascot database search (Figure D). This peptide has the sequence GLVLIAFSQYLQQCPFDEHVK and could be unambiguously identified as a BSA fragment.. A B 3 CONCLUSION Monolithic nanocolumns and capillary (polymerbased) columns show excellent separation performance. The same column can be used for both protein and peptide separations. To achieve separation efficiencies of up to, plates/m, the use of a dedicated nano HPLC system with zero dead volumes is required. Using -cm columns results in very fast protein and peptide separations with a PWHH of only a few seconds. The monolithic structure is also advantageous because the very robust column bed results in zero voiding and a superior column lifetime. Coupled to MS, Monolithic nanocolumns and capillary columns allow for high-throughput and sensitive analysis for peptides and proteins, independent of the mobile phase additive (TFA or FA)....8 7. 7. 8... y() 7. 7.9 y(8)++ b() y(9)++ 78. 89. 9.... 33...7.7 8 m/z y*()++ y()++ b(7) b*()++ y(7) y()++ y ()++ y()++ y* ()++ y (7)++ b (9)++ b () yo(8)++ y(8)++ y(9)++ b() y () b() b(3) C D GLVLIAFSQYLQQCPFDEHVK 8 m/z 3 Figure 7. (A) LC/MS using a Monolithic capillary column (PS-DVB based). BPC of digested protein mixture. Injected amount fmol. Dashed lines represent zoom-in of Figure D. (B) Zoom-in of BPC with an arbitrarily chosen tryptic peptide ( ) used for MS and MS/MS investigation. (C) MS/MS of tryptic peptide, eluting at 7. min with m/z 83.. (D) Mascot search. Fast Protein and Peptide Separations Using Monolithic Capillary Columns and Nanocolumns
REFERENCES. Premstaller, A.; Oberacher, H.; Walcher, W.; Timperio, A. M.; Zolla, L.; Chervet, J. P.; Cavusoglu, N; van Dorsselaer, A.; Huber, C. G. High Performance Liquid Chromatography: Electrospray Ionization Mass Spectrometry Using Monolithic Capillary Columns for Proteomic Studies. Anal. Chem., 73, 39 39. Walcher, W.; Oberacher, H.; Troiani, S.; Holzl, G.; Oefner, P.; Zolla, L.; Huber, C. G. Monolithic Capillary Columns for Liquid Chromatography: Electrospray Ionization Mass Spectrometry in Proteomic and Genomic Research. J. Chromatogr., B, 78,. Mascot is a registered trademark of Matrix Science Ltd. UltiMate and FAMOS are trademarks of Dionex Corporation. Dionex Corporation Dionex Corporation Dionex U.S. Regional Offices Dionex International Subsidiaries 8 Titan Way Salt Lake City Technical Center Sunnyvale, CA (8) 737-8 Australia () 9 33 Austria () Belgium (3) 33 9 Canada (9) 8-9 China (8) 8 38 P.O. Box 33 West South, Suite A Westmont, IL (3) 789-3 Denmark 3 3 9 9 France 39 3 Germany -99- Italy () Japan () 88-3 Sunnyvale, CA Salt Lake City, UT Houston, TX (8) 87- Korea 8 3 8 The Netherlands () 3 3 3 Switzerland () 99 United Kingdom (7) 97 988-33 89-8 Atlanta, GA (77) 3-8 * Designed, developed, and manufactured under an NSAI registered ISO 9 Quality System. (8) 737-7 (8) 97-99 Marlton, NJ (8) 9-9 LPN 98- PDF / Application Note 3 Dionex Corporation