A. OTHER JUNCTIONS B. SEMICONDUCTOR HETEROJUNCTIONS -- MOLECULES AT INTERFACES: ORGANIC PHOTOVOLTAIC BULK HETEROJUNCTION DYE-SENSITIZED SOLAR CELL

Similar documents
A. OTHER JUNCTIONS B. SEMICONDUCTOR HETEROJUNCTIONS -- MOLECULES AT INTERFACES: ORGANIC PHOTOVOLTAIC BULK HETEROJUNCTION DYE-SENSITIZED SOLAR CELL

A. OTHER JUNCTIONS B. SEMICONDUCTOR HETEROJUNCTIONS -- MOLECULES AT INTERFACES: ORGANIC PHOTOVOLTAIC BULK HETEROJUNCTION DYE-SENSITIZED SOLAR CELL

SEMICONDUCTOR HETEROJUNCTIONS

SEMICONDUCTOR PHYSICS REVIEW BONDS,

Photovoltaics. Lecture 7 Organic Thin Film Solar Cells Photonics - Spring 2017 dr inż. Aleksander Urbaniak

The discussion about p-n junctions in the semiconductor device is fundamental both

Mesoporous titanium dioxide electrolyte bulk heterojunction

Organic Electronic Devices

Solar Cell Materials and Device Characterization

Schottky Rectifiers Zheng Yang (ERF 3017,

Nanotechnology and Solar Energy. Solar Electricity Photovoltaics. Fuel from the Sun Photosynthesis Biofuels Split Water Fuel Cells

Effective masses in semiconductors

Review Energy Bands Carrier Density & Mobility Carrier Transport Generation and Recombination

* motif: a single or repeated design or color

Semiconductor Junctions

Semiconductor Physics and Devices

V BI. H. Föll: kiel.de/matwis/amat/semi_en/kap_2/backbone/r2_2_4.html. different electrochemical potentials (i.e.

1 Name: Student number: DEPARTMENT OF PHYSICS AND PHYSICAL OCEANOGRAPHY MEMORIAL UNIVERSITY OF NEWFOUNDLAND. Fall :00-11:00

Qualitative Picture of the Ideal Diode. G.R. Tynan UC San Diego MAE 119 Lecture Notes

Chemistry Instrumental Analysis Lecture 8. Chem 4631

Classification of Solids

Lecture 2. Introduction to semiconductors Structures and characteristics in semiconductors

The Meaning of Fermi-Level And Related Concepts (Like Band-Bending)

Lecture 2. Introduction to semiconductors Structures and characteristics in semiconductors. Fabrication of semiconductor sensor

KATIHAL FİZİĞİ MNT-510

Surfaces, Interfaces, and Layered Devices

Lecture 2. Introduction to semiconductors Structures and characteristics in semiconductors

ECE 440 Lecture 20 : PN Junction Electrostatics II Class Outline:

Surfaces, Interfaces, and Layered Devices

PHYS208 p-n junction. January 15, 2010

The photovoltaic effect occurs in semiconductors where there are distinct valence and

Figure 3.1 (p. 141) Figure 3.2 (p. 142)

MOS Capacitor MOSFET Devices. MOSFET s. INEL Solid State Electronics. Manuel Toledo Quiñones. ECE Dept. UPRM.

Charge Carriers in Semiconductor

2.626 Fundamentals of Photovoltaics

Numerical model of planar heterojunction organic solar cells

Semiconductor Physics. Lecture 3

- A free electron in CB "meets" a hole in VB: the excess energy -> a photon energy.

UNIVERSITY OF CALIFORNIA College of Engineering Department of Electrical Engineering and Computer Sciences. EECS 130 Professor Ali Javey Fall 2006

Nanomaterials for Photovoltaics (v11) 14. Intermediate-Band Solar Cells

3. Two-dimensional systems

Appendix 1: List of symbols

CHARGE CARRIERS PHOTOGENERATION. Maddalena Binda Organic Electronics: principles, devices and applications Milano, November 23-27th, 2015

A. K. Das Department of Physics, P. K. College, Contai; Contai , India.

Session 6: Solid State Physics. Diode

EECS130 Integrated Circuit Devices

Consider a uniformly doped PN junction, in which one region of the semiconductor is uniformly doped with acceptor atoms and the adjacent region is

The pn junction. [Fonstad, Ghione]

Avalanche breakdown. Impact ionization causes an avalanche of current. Occurs at low doping

8. Schottky contacts / JFETs

Schottky diodes. JFETs - MESFETs - MODFETs

Electrons, Holes, and Defect ionization

Laurence M Peter Department of Chemistry, University of Bath, Bath BA2 7AY, United Kingdom

ECE 340 Lecture 21 : P-N Junction II Class Outline:

Effect of doping on performance of organic solar cells

smal band gap Saturday, April 9, 2011

Silicon. tetrahedron diamond structure

Sheng S. Li. Semiconductor Physical Electronics. Second Edition. With 230 Figures. 4) Springer

Module-6: Schottky barrier capacitance-impurity concentration

ECE 606 Homework Week 7 Mark Lundstrom Purdue University (revised 2/25/13) e E i! E T

Basic cell design. Si cell

Solid State Physics SEMICONDUCTORS - IV. Lecture 25. A.H. Harker. Physics and Astronomy UCL

Metal Semiconductor Contacts

CLASS 12th. Semiconductors

Lecture 9: Metal-semiconductor junctions

Planar Organic Photovoltaic Device. Saiful I. Khondaker

Surface Transfer Doping of Diamond by Organic Molecules

Theory of Electrical Characterization of Semiconductors

ECE236A Semiconductor Heterostructure Materials Basic Properties of Semiconductor Heterostructures Lectures 2 & 3 Oct. 5, 2017

Ba x Sr 1-x TiO 3 /pc-si HETEROJUNCTION

Chapter 3 Modeling and Simulation of Dye-Sensitized Solar Cell

Chapter-II CHEMISTRY OF PHOTOELECTRODE- ELECTROLYTE INTERFACE

Introductory Nanotechnology ~ Basic Condensed Matter Physics ~

Lecture 5 Junction characterisation

Conductivity and Semi-Conductors

Photovoltaic Energy Conversion. Frank Zimmermann

n N D n p = n i p N A

Organic solar cells. State of the art and outlooks. Gilles Horowitz LPICM, UMR7647 CNRS - Ecole Polytechnique

PHYSICAL ELECTRONICS(ECE3540) CHAPTER 9 METAL SEMICONDUCTOR AND SEMICONDUCTOR HETERO-JUNCTIONS

Chap. 11 Semiconductor Diodes

ET3034TUx Utilization of band gap energy

Schottky Diodes (M-S Contacts)

Review of Semiconductor Fundamentals

Electrons are shared in covalent bonds between atoms of Si. A bound electron has the lowest energy state.

PHYS208 P-N Junction. Olav Torheim. May 30, 2007

Stanford University MatSci 152: Principles of Electronic Materials and Devices Spring Quarter, Final Exam, June 8, 2010

Semiconductor. Byungwoo Park. Department of Materials Science and Engineering Seoul National University.

Lecture 15: Optoelectronic devices: Introduction

Final Examination EE 130 December 16, 1997 Time allotted: 180 minutes

Senior Project Thesis Senior Project Committee, Department of Physics, Case Western Reserve University

Introduction to Organic Solar Cells

1. Binary III-V compounds 2 p From which atoms are the 16 binary III-V compounds formed?...column III B, Al, Ga and In...column V N, P, As and Sb...

Band-bending. EE 436 band-bending 1

Lecture 18: Semiconductors - continued (Kittel Ch. 8)

e - Galvanic Cell 1. Voltage Sources 1.1 Polymer Electrolyte Membrane (PEM) Fuel Cell

Chapter 7. The pn Junction

PRESENTED BY: PROF. S. Y. MENSAH F.A.A.S; F.G.A.A.S UNIVERSITY OF CAPE COAST, GHANA.

Towards a deeper understanding of polymer solar cells

Semiconductor Device Physics

Semiconductor Devices and Circuits Fall Midterm Exam. Instructor: Dr. Dietmar Knipp, Professor of Electrical Engineering. Name: Mat. -Nr.

Transcription:

A. OTHER JUNCTIONS B. SEMICONDUCTOR HETEROJUNCTIONS -- MOLECULES AT INTERFACES: ORGANIC PHOTOVOLTAIC BULK HETEROJUNCTION DYE-SENSITIZED SOLAR CELL March 24, 2015 The University of Toledo, Department of Physics and Astronomy SSARE, PVIC Principles and Varieties of Solar Energy (PHYS 4400)

p-n junction and semiconductor physics review A note on units: looking at the Continuity equation(s) units for dn/dt are cm -3 s -1. Units for (1/q)(dJ/dx) work out to be: (C -1 )(C s -1 cm -2 )(cm -1 ) = cm -3 s -1.

p-n junction and semiconductor physics review Poisson s Equation deˆ dx q ( p n N D N A ) Straightforward definitions: E is the electric field is the charge density q is the magnitude of the electron charge p is the concentration of free holes n is the concentration of free electrons N D + is the concentration of ionized donor atoms (recall that donors donate electrons, leaving them positively charged) N A - is the concentration of ionized acceptor atoms (recall that acceptors accept electrons, leaving them negatively charged)

Semiconductor physics review Density of States in Conduction and Valence Band (parabolic band approximation) N N C V E E mn 2 m 3/ 2 3 3/ 2 p 2 3 2 2 E E E V C E Look at units: (note that 1 J = 1 kg-m 2 -s -2, and [h] = m 2 kg s -1 ) kg 3/ 2 J 1/ 2 6 3 m kg s 3 kg 3/ 2 kg 1/ 2 6 3 m kg s s 3 m kg 1 s 2 m 5 J 1 m 3 Fermi function (state occupation probability) f E 1 E E 1 exp kt F

Junctions Reading assignments: Work Function: http://en.wikipedia.org/wiki/work_function Electron Affinity (solid state physics): http://en.wikipedia.org/wiki/electron_affinity Vacuum Level: http://en.wikipedia.org/wiki/vacuum_level Fermi Energy: http://en.wikipedia.org/wiki/fermi_energy Fermi Level: http://en.wikipedia.org/wiki/fermi_level Work Function: potential required to remove the least tightlybound electron: w E vac E F Work function equals the electron affinity in metals.

Bases for effective fields at junctions Charge-separation mechanisms gradient in the vacuum level or work function electrostatic field (e.g., doping level) gradient in electron affinity effective field gradient in the band gap effective field gradient in the band DOS effective field

Metal-semiconductor junctions: Schottky-barrier m n In contact: electrons flow from semiconductor to metal, resulting in a layer of positive fixed charge in the semiconductor, near the surface (and a negative image charge on the metal); Fermi levels equilibrate; Potential difference drops in the semiconductor (space charge, and/or depletion, region); Result is a lower resistance pathway for holes than for electrons

Metal-semiconductor junctions: Schottky-barrier (cont.) Under illumination, holes flow to the right, and electrons accumulate in the semiconductor; Fermi level shifts up in the semiconductor (accumulation of electrons); Result is a photovoltage

Metal-semiconductor junctions: Schottky-barrier (cont.)

Metal-semiconductor junctions: Schottky-barrier (cont.) m p In contact: holes flow from the semiconductor to the metal, resulting in a layer of negative fixed charge in the semiconductor near the surface (and a positive image charge on the metal); Fermi levels equilibrate; Potential difference drops in the semiconductor (space charge, and/or depletion, region); Result is a lower resistance pathway for electrons (to the metal) than for holes Under illumination, electrons flow into the metal from the semiconductor

Metal-semiconductor junctions: Ohmic contact m n m p Note that at Ohmic contact provides a low resistance pathway for majority carrier from the semiconductor to the metal

Organic PV: Bulk heterojunction http://depts.washington.edu/cmditr/mediawiki/inde x.php?title=organic_heterojunctions_in_solar_cells http://www-ssrl.slac.stanford.edu/sites/default/files/sciencehighlights/images/2011/january/verploegen--fig1_0.png

Organic PV: simplified BH structure http://www.light.t.utokyo.ac.jp/english/photovoltaic/introduction.html http://www.cfn.uni-karlsruhe.de/?id=221 M. Al-Ibrahima et al., Solar Energy Materials & Solar Cells 85 (2005) 13 20

Organic PV: interface energetics http://depts.washington.edu/cmditr/mediawiki/images/8/84/or ganicheterojunctions.jpg http://www.physik.uniwuerzburg.de/ep6/research-oe.html

Dye-sensitized TiO 2 solar cell ~25 nm nano-porous TiO 2 electrode HOMO-LUMO transition Reaction : S + h S * S + + e - M. Grätzel / Journal of Photochemistry and Photobiology C: Photochemistry Reviews 4 (2003) 145 153

Dye-sensitized TiO 2 solar cell Binding of dye (monolayer) to TiO 2 through carboxylate groups; photon absorption results in metal-to-ligand charge transfer (MLCT) and rapid injection (<20 fs) of the e - into the TiO 2 CB. M. Grätzel / Journal of Photochemistry and Photobiology C: Photochemistry Reviews 4 (2003) 145 153