MARS DROP. Matthew A. Eby Mechanical Systems Department. Vehicle Systems Division/ETG The Aerospace Corporation May 25, 2013

Similar documents
Small Entry Probe Trajectories for Mars

Entry, Descent and Landing Technology Advancement

Aeromaneuvering/Entry, Descent, Landing

Performance Characterization of Supersonic Retropropulsion for Application to High-Mass Mars Entry, Descent, and Landing

Numerical Simulations of the Mars Science! Laboratory Supersonic Parachute!

Mars Entry, Descent, and Landing Parametric Sizing and Design Space Visualization Trades

SCIENCE WITH DIRECTED AERIAL DR. ALEXEY PANKINE GLOBAL AEROSPACE CORPORATION SAILING THE PLANETS

SAILING THE PLANETS: PLANETARY EXPLORATION FROM GUIDED BALLOONS. 7 th Annual Meeting of the NASA Institute for Advanced Concepts

FLIGHT RECONSTRUCTION OF THE MARS PATHFINDER DISK-GAP-BAND PARACHUTE DRAG COEFFICIENT

High Mass Mars Entry, Descent, and Landing Architecture Assessment

Large Supersonic Ballutes: Testing and Applications FISO Telecon

Mars Exploration Entry, Descent and Landing Challenges

Guided Entry Performance of Low Ballistic Coefficient Vehicles at Mars

MISSION PROFILE AND DESIGN CHALLENGES FOR MARS LANDING EXPLORATION

SUPERSONIC PARACHUTE AERODYNAMIC TESTING AND FLUID STRUCTURE INTERACTION SIMULATION

Numerical Simulation of Flow Field around an Inflatable Vehicle during a Reentry Demonstration Flight considering Membrane Deformation

Conceptual Modeling and Analysis of Drag- Augmented Supersonic Retropropulsion for Application in Mars Entry, Descent, and Landing Vehicles

GUIDANCE TRADES FOR HIGH BALLISTIC COEFFICIENT MARS LANDER TRAJECTORIES

Parachute systems for the atmospheric reentry of launcher upper stages

The Archimedes Mars balloon project and the MIRIAM test flights Part 1: from Archimedes to MIRIAM

IPPW Bio: Robert Dillman BS Aerospace Engineering, University of Virginia 1989; Masters of Materials Science, University of Virginia 1997 NASA

Supersonic Retropropulsion Technology for Application to High Mass Mars Entry, Descent, and Landing

IAC-08-D2.3.9 A CONCEPT FOR THE ENTRY, DESCENT, AND LANDING OF HIGH-MASS PAYLOADS AT MARS

Creating Large Space Platforms From Small Satellites

Design and analysis of parachute triggering algorithms for re-entry vehicles

LAB 2 HOMEWORK: ENTRY, DESCENT AND LANDING

Launch Vehicle Family Album

Section 3.5 Recovery Systems: Parachutes 101

Rocket Science, Reentry and the Race to Mars. From Science Fiction to Simulation

1. INTRODUCTION. Gregg Barton Charles Stark Draper Laboratory El Camino Real, Suite 470 Houston, TX

Review of the Trajectory and Atmospheric Structure Reconstruction for Mars Pathfinder

Trajectory Trade-space Design for Robotic. Entry at Titan

Future Development Plan of Sample return Capsule evolved on the basis of HAYABUSA SRC heritage

Verifying Volatile Volcanoes on Venus

ADVANCES IN GUIDANCE, NAVIGATION, AND CONTROL FOR PLANETARY ENTRY, DESCENT, AND LANDING SYSTEMS

Separable warhead mathematical model of Supersonic & Hypersonic Re-entry Vehicles

Initial Trajectory and Atmospheric Effects

4.8 Space Research and Exploration. Getting Into Space

Aerothermodynamics for Dragonfly s Titan Entry

SPACE DEBRIS MITIGATION TECHNOLOGIES

Ball Aerospace & Technologies Corp. & L Garde Inc.

MONTGOLFIERE BALLOON MISSIONS FOR MARS AND TITAN

BRINGING YOUR EXPERIMENT INTO SPACE

9.2 Worksheet #3 - Circular and Satellite Motion

Design of Orbits and Spacecraft Systems Engineering. Scott Schoneman 13 November 03

Aerosciences Considerations in the Design of a Powered Descent Phase for Human-Scale Mars Lander Vehicles

SOLAR MONTGOLFIERE BALLOONS FOR MARS

HYBRID AEROCAPTURE USING LOW L/D AEROSHELLS FOR ICE GIANT MISSIONS

From Celestial North, this is IT S OVER YOUR HEAD for the week of. The New Year brought together revelers the world over for jubilant parties

Parametric Design MARYLAND. The Design Process Level I Design Example: Low-Cost Lunar Exploration U N I V E R S I T Y O F

Mars Sample Return (MSR) Mission BY: ABHISHEK KUMAR SINHA

Space Debris Reentry Hazards

Paper Session II-B - The Mars Environmental Survey (MESUR) Network and Pathfinder Missions

PSI AP Physics 1 Gravitation

21 JSTS Vol. 27, No. 2

Flow Simulation over Re-Entry Bodies at Supersonic & Hypersonic Speeds

OPEN THALES ALENIA SPACE

Autonomous Formation Flying and Proximity Operations using Differential Drag on the Mars Atmosphere

PRECISION LANDING AT MARS USING DISCRETE-EVENT DRAG MODULATION

Abstract. THOMAS, CASEY. Aerodynamic Validation using MER and Phoenix Entry Flight Data. (Under the supervision of Dr. Robert Tolson.

MASS MODEL DEVELOPMENT FOR CONCEPTUAL DESIGN OF A HYPERSONIC RIGID DEPLOYABLE DECELERATOR

AEROTHERMODYNAMIC ANALYSIS OF INNOVATIVE HYPERSONIC DEPLOYABLE REENTRY CAPSULES. Raffaele Savino University of Naples Federico II

A simplified trajectory analysis model for small satellite payload recovery from low Earth orbit

Mars Precision Entry Guidance Using Internal Moving Mass Actuators

Atmospheric Entry. Technology, Mathematical Model and Simulation

Opportunities for Small Satellites and Space Research Using the K-1 Vehicle

Small Satellite Aerocapture for Increased Mass Delivered to Venus and Beyond

Report Team /09/2012

The Design Process Level I Design Example: Low-Cost Lunar Exploration Amplification on Initial Concept Review

Venus Bridge: Orbiter and atmospheric element

ENAE 791 Course Overview

Human Spaceflight Value Study Was the Shuttle a Good Deal?

Rapid De-Orbit of LEO Space Vehicles Using Towed Rigidizable Inflatable Structure (TRIS) Technology: Concept and Feasibility Assessment

Design of a High Altitude Balloon Drop Test for SPORE (Small Probes for Orbital Return of Experiments)

CHARACTERIZATION OF GUIDANCE ALGORITHM PERFORMANCE FOR DRAG MODULATION-BASED AEROCAPTURE

PHYSICS 3300 Case Study - Falling through Jupiter

ADEPT, A Mechanically Deployable Re-Entry Vehicle System, Enabling Interplanetary CubeSat and Small Satellite Missions

ENAE 483/788D MIDTERM FALL, 2018 NAME: a 3 = a = 42970] 1. So after one sol, the subspacecraft point would have gone 88773

MARYLAND. The Design Process Regression Analysis Level I Design Example: UMd Exploration Initiative U N I V E R S I T Y O F.

REENTRY OF SPACE CRAFT TO EARTH ATMOSPHERE. By Alexander Bolonkin

ESSE Payload Design. 1.2 Introduction to Space Missions

II. Current and Recommended State of Knowledge

Planning for a Supersonic Retropropulsion Test in the NASA Langley Unitary Plan Wind Tunnel

Small Satellite Aerocapture for Increased Mass Delivered to Venus and Beyond

A COMMON PROBE DESIGN FOR MULTIPLE PLANETARY DESTINATIONS

SUBSONIC AND TRANSONIC WIND TUNNEL TESTING OF TWO INFLATABLE AERODYNAMIC DECELERATORS

Chariot. to the Moons of Mars. Z. R. Putnam. University of Illinois at Urbana-Champaign. Zachary R. Putnam

Suggestions for Making Useful the Uncertainty Quantification Results from CFD Applications

Overview of Orion Aerodynamics: Database Development and Flight Test Comparisons

De-orbiting Small Satellites Using Inflatables

PAYLOAD CONCEPT PROPOSAL VENUS EXPLORER MISSION

Advanced drop tests from stratospheric balloons

Irvine. Salton Sea. Palm Springs. Interstate 10

Parachute Dynamic Stability and the Effects of Apparent Inertia

Minimum-Mass Limit of Venus Atmospheric Probes

Circular vs. Elliptical Orbits for Persistent Communications

RE-ENTRY TRAJECTORY SIMULATION OF A SMALL BALLISTIC RECOVERABLE SATELLITE

InSight Spacecraft Launch for Mission to Interior of Mars

Testing the Composition of Ganymede

Lunar Flashlight Project

Transcription:

MARS DROP Matthew A. Eby Mechanical Systems Department Vehicle Systems Division/ETG The Aerospace Corporation May 25, 2013 The Aerospace Corporation 2013

The Aerospace Corporation (Aerospace), a California nonprofit corporation has flown 20 small satellites over the past 15 years. 2 Photograph courtesy of NASA

MARS DROP Landing System for a Mars Planetary Micro-probe Objective MARS DROP is an Aerospace research project to adapt Aerospace s REBR (Reentry Breakup Recorder) vehicle for use as a Planetary micro-probe Existing aeroshell is well suited for Mars entry (aerodynamically stable) Simply need to add a landing system Research objective to demonstrate proof-ofconcept landing system that leaves sufficient volume for a useful scientific payload. Approach Engage with scientific community from outset Collaboration with Planetary Science Institute Architect three aspects Backshell separation mechanism Deployment of aerodynamic drag device Terminal landing hardware Test on Earth with high altitude balloon deployments REBR Key Milestones Landing Architecture Study Fall 2012 First High Altitude Field Test Soon Complete Detailed Design Fall 2013 Final High Altitude Field Test 2014 3

Entry, Descent, & Landing 7 Minutes of Terror Progressively larger NASA Mars Landers have produced progressively more exciting landings (e.g. MSL s 7 Minutes of Terror ) Larger mass densities equate to higher ballistic coefficients and faster terminal velocities, requiring complex multi-stage, supersonic deceleration Multi-stage, supersonic deceleration is untestable as a system on Earth (cost prohibitive) A micro-probe has the advantage of going smaller, with a low ballistic coefficient that greatly simplifies the landing architecture. A sufficiently low ballistic coefficient will produce a subsonic terminal velocity, requiring a simple, single-stage, subsonic deceleration to reach landing velocity Single stage, subsonic deceleration is easily tested on Earth Drop testing at high altitudes (where atmosphere has same density as Mars surface) Chute Deploy ~ Mach 0.8 Chute Deploy ~ Mach 2 Pathfinder / MER / MSL 4

Mach Number Entry, Descent, & Landing Ballistic Mars Entry Curves Pathfinder, 68 kg/m 2, Entry at 7.3 km/sec & -14.2 3-DOF Simulation (Range, Height, Orientation) Spirit/Opportunity, 97 kg/m 2, Entry at 5.5 km/sec & -11.5 Parachute Window Mars DROP, 35 kg/m 2, Entry at 6.9 km/sec & -13.25 * 5 Altitude (km) Mach 1 Microprobe goes subsonic around 10 km subsonic landing system Pathfinder, Spirit, Opportunity, MSL all supersonic during parachute deploy *Microprobe goes subsonic across wide range of entry parameters

Aerodynamic Decelerator Trade Study Available Volume is the Limiting Factor Concepts: Solid Circular Parachute Disk-Gap-Band Parachute Inflatable Decelerator Vortex Ring Parachute Parawing Claim to Fame Standard Round Solid Parachute Used on all NASA Mars Landers Targeted for future NASA Mars Landers Highest Drag Supersonic No Yes Yes Unreliable No Gliding Chute Complexity Low Low High High (Swivel) Medium Prior Research Extensive Extensive Moderate Minimal Moderate Subsonic Drag Moderate (C D ~ 0.9) Mass / Volume for 7.5m/s vertical velocity (reference V) Notes / Landing Site Limitations Low (C D ~ 0.6) Moderate (C D ~ 0.8) Very High (C D ~ 2.0) Very Low (C D ~ 0.3), but Lift 1.1 kg / 2300 cm 3 1.7 kg / 3480 cm 3 2.5 kg / 5200 cm 3 0.5 kg / 1050 cm 3 0.1 kg / 200 cm 3 Poor subsonic drag prompts two-stage deceleration Is attractive for much larger vehicles Suspect Reliability Horizontal velocity -could be good or bad 6 ~ 3000 cm 3 internal volume

Why a Parawing Back to the Future NASA studied parawings in the 1960 s for Gemini & Apollo reentry vehicles, but ultimately did not employ them. For a Mars microprobe they are attractive We are volume limited, so the Lifting action (L/D ~ 3) sets up a glide path that greatly reduces the vertical landing velocity By far smallest volume amongst options We have a subsonic deployment and deceleration, where parawings are usable Extensive existing database of aerodynamic characteristics for microprobe design sizing Steerable & will glide for km! Image Courtesy of NASA 7

Parawing Challenges and why Gemini astronauts never glided back home It kicks like a mule during inflation, 2-3 times higher transient loads than an equivalent circular chute But lightweight instruments designed to MAC (Mass Acceleration Curve) launch loads should be able to handle this better than astronauts It s a bit of a packing nightmare, with 275 feet of rigging line But the advent of high performance synthetic fibers (Spectra) keeps the stowed volume small 8

Landing Architecture Entry Interface 100 km, V=7km/sec T+1 min, Max Q 35 km, 15 g s T+3 min, Backshell Sep. 6.5 km, Mach 0.85 3-DOF Simulation (Range, Height, Orientation) T+3 min, Main Deploy 6.5 km, 200m/sec T+3 min, Peak Inflation Load 6.5 km, 65 g s T+10 min, Terminal Landing 3.0 km, Vertical < 7.5 m/sec Foreground Image Courtesy of NASA 9

High Altitude Testing Going to Mars on Earth Low density Mars surface atmosphere is replicated on Earth at high altitude (~100,000 feet), reachable for small payloads with weather balloons Test in stages Deployment tests of the Parawing across Q (dynamic pressure) bounds Proof-of-concept demonstrations for the full landing system Transition capability to mission development Approach yields high fidelity testing at minimal cost Small fraction of cost traditionally expended for verifying a descent and landing architecture 10

Test Architecture Release Target Drop Altitude 90k 100k feet Accelerate to Dynamic Pressure Launch Conduct Test Beacon 430 MHz Position & Telemetry 144.39 MHz 11

Let s Propose a Mars Mission Together Some Design Parameters REBR has a history of riding on NASA & ESA spacecraft Who wants to try to hitchhike on a forthcoming Mars bound spacecraft? The parawing is sized to land a 3 kg probe (~1 kg available for the science payload) at most elevations on Mars Who wants to target an interesting but risky location the expensive rovers steer clear of? A parawing is steerable and will glide for kilometers over 10 or more minutes Who wants to fly into Valles Marineris? It s a Cubesat in a reentry package, so its pretty cheap (relatively speaking) Who wants to send a dozen as a distributed science project (weather, seismic, etc.)? 1.) Pick any Location (almost) 2.) Select the Science 3.) Design for Launch & EDL Packed Chute / Backshell Adhere to those Mass Acceleration Curve Loads (~60 g s) Range Enabled Science Probe / Forebody? 12 Map Courtesy of NASA ~ 3000 cm 3 internal volume

M RS DROP LET S DISCUSS COLLABORATING 13

References 1. NASA Technical Note D-5965 LOW-SPEED WIND TUNNEL INVESTIGATION OF ALL-FLEXIBLE TWIN- KEEL TENSION-STRUCTURE PARAWINGS, 1970. 2. NASA Technical Note D-5793 PERFORMANCE AND DEPLOYMENT CHARACTERISTICS OF A TWIN-KEEL PARAWING WITH VARIOUS AMOUNTS AND PERMEABILITIES OF POROUS MATERIAL IN OUTER LOBES, 1970. 14