A Fast and Sensitive Method for Residual Hydrazine Analysis in Pharmaceutical Samples Vera Leshchinskaya, Priscilla Richberg, Yury Zelechonok*, and Anne Kelly Bristol Myers Squibb Company, P.O.BOX 4000, Princeton, NJ, 08543, * SIELC Technologies, 65 E. Palatine Rd., Suite 221, Prospect Heights, IL 60070
Hydrazine is Hydrazine Properties H 2 N NH 2 a highly reactive molecule widely used in chemical syntheses of intermediates and active pharmaceutical ingredients a known carcinogen - can have an impact on product risk assessment if present in the final drug substance and drug product as an impurity. a small, polar, basic molecule with no chromophore
Objective Develop a method for detection of low (ppm) level of hydrazine in pharmaceutical samples and wash solutions. Method criteria: simple sample preparation step efficiency sensitivity ease of transfer
Control of Genotoxic Impurities in Pharmaceuticals According to current regulatory guidance, it is assumed that genotoxic compounds have the potential to damage DNA at very low level of exposure. Thus, actual and potential impurities most likely to arise during synthesis, purification, and storage should be identified. Both the EMEA guidelines and a PhRMA white paper propose a limit of 1.5 µg/day for genotoxic impurities in pharmaceuticals.
Analytical Challenges in Setting Limits for Genotoxic Impurities Low level (ppm) needs to be detected Many genotoxic impurities are highly reactive and therefore difficult to analyze Sample matrix can be chemically similar and present at extremely high level Techniques being employed aren t standard and may present significant technology transfer issues
Analytical Background Existing methods for hydrazine are mostly applicable to environmental samples (water,air,soil) employ sophisticated equipment and/or derivatization tend to be cumbersome and time consuming are subject to interference, especially by hydrazine derivatives (colorimetric and titrimetric methods)
GC Analysis of Residual Hydrazine CH 3 CH 3 H 3 C N H 2 N NH 2 + 2 O N CH 3 CH 3 H 3 C Advantages of using Acetone: Serves as both diluent and derivatizing agent Symmetrical molecule (produces only one isomer) Fast reaction rate Low toxicity Good GC separation from the product of the reaction.
GC Analysis of Acetone Azine pa 220.00 200.00 180.00 160.00 140.00 120.00 100.00 Acetone Acetone azine - 2.822 Acetone impurity 3.708 Oven Program: Initial temperature: 95 C 1 2 3 Rate 10.0 30.0 40.0 Final 120.0 225.0 95.0 Hold Time 0.00 4.00 1.00 Total Time 3.50 11.00 15.25 80.00 60.00 40.00 20.00 2.531 3.274 1.00 2.00 3.00 4.00 5.00 6.00 7.00 8.00 9.00 10.00 11.00 12.00 13.00 14.00 15.00 Minutes Column:20-m length x 0.18-mm i.d., 1µm film thickness, 6% cyanopropylphenyl-94% dimethylpolysiloxane (DB-624); Detector: FID, 280 C; Injector: 1 μl into the split port maintained at 200 C; Carrier Gas: Helium; Column Flow: 1.3 ml/min; Split ratio/split Flow: 110/143 ml/min.
Linearity Data for Acetone Azine 100 90 80 y = 105.48x + 0.0297 R 2 = 0.9999 Concentration mg/ml ppm 0.000842 0.84 Peak Area 0.1168 Peak Area 70 60 50 40 30 0.005052 0.00842 0.05052 0.0842 0.5052 0.842 5.05 8.40 50.5 84.2 505.2 842.0 0.5077 0.8384 5.2658 8.8097 54.1033 88.3914 20 10 0 0 0.2 0.4 0.6 0.8 1 Concentration (mg/ml) S/N at 0.84 ppm is ~10:1 0.84 ppm of Acetone azine corresponds to 0.24 ppm of free hydrazine in solution or 2.4 ppm/100 mg of sample
Conversion of Hydrazine Mono-Hydrate to Acetone Azine: GC/MS Data CH 3 H 2 N NH 2 + 2 O CH 3 CH 3 H 3 C H 3 C N NH 2 MW=72 H 3 C H 3 C N N CH 3 MW=112 pa 160.00 140.00 120.00 100.00 80.00 60.00 40.00 20.00 0.00 acetone - 1.007 30 30 31 39 40 41 54 50 57 60 72 70 m/z mono-substituted - 2.010 0.50 1.00 1.50 2.00 2.50 3.00 3.50 Minutes 80 90 100 110 Acetone azine - 2.885 28 40 39 52 56 70 67 60 m/z 80 80 97 112 95 100
Conversion Rate of Hydrazine Mono- Hydrate to Acetone Azine Area counts 400 350 300 250 200 150 100 50 0 Rate of Conversion of Hydrazine to Acetone azine Acetone Azine Propane-2-ylidenhydrazine 0 200 400 600 800 Time, min %Conversion 5 10.3 103 22.8 153 29.1 170 31.7 187 34.1 204 36.8 259 37.5 276 39.7 573 69.1 590 77.0 Time, min
Reaction Conversion of Hydrazine Mono-Hydrate to Acetone Azine Catalyzed by Acid Time, min % Conversion, Acetone Hydrazone/ Acetone Azine 0 HCOOH 0/100 CH3COOH 5.5/94.5 15 0/100 0/100 Conclusion : The derivatization proceeds in less than 3 min in the presence of formic acid and within ~15 min with Acetic Acid.
Reaction Conversion of Hydrazine Dihydrochloride to Acetone Azine Problem: Low solubility of the salt in acetone Conversion rate is ~50% within 24 hours Solution: Standard prep - dissolved~ 10 mg/2 ml of H2O - diluted with acetone to 200 ml The derivatization proceeds in 2.5 hours (97.5%). Presence of formic acid did not show improvement in the reaction rate
Sample Analysis for Residual Hydrazine. H N Problem: ~100 mg needed to be dissolved in 1 ml of acetone for ppm level hydrazine analysis. Solution: Sample prep - added 1 ml of 1/99 H2O/Acetone to 100 mg of the sample. - Heated at~ 40 o C. Mixed well. The solution became clear for a short period of time (1-2 minutes) and then the precipitate formed again under cooling to room temperature. Question: Did the reaction occur or did the recrystallization take place? NH 2 N * HCl Compound A
1 H NMR Spectra Comparison (1) H 3 C CH 3 DMSO-d6 10.00 3.15 9.41 6.89 6.92 6.93 7.02 7.16 7.17 7.28 7.31 7.41 7.42 7.96 7.96 7.97 2.49 2.74 1.00 1.02 1.03 0.99 0.99 0.01 11.25 2.49 7.49 7.67 7.69 7.82 7.83 1.95 2.00 2.03 2.04 2.07 7.38 7.24 7.46 7.47 6.95 7.23 6.94 6.92 2.16 2.12 NH 2 H N N H N * HCl N N DMSO-d6, 400 MHz Compound A Precipitate from Acetone, yield is ~100% 13 12 11 10 9 8 7 6 5 4 3 2 1 0 Chemical Shift (ppm)
1 H NMR Spectra Comparison (2) DMSO-d6, 400 MHz Acetone layer 11.12 11.13 11.14 11.15 11.16 7.18 1.66 1.75 1.78 7.47 7.67 7.69 7.82 7.83 7.22 7.23 7.37 7.45 6.94 6.93 6.91 2.49 2.15 1.82 1.97 2.10 Precipitate from Acetone spiked with Acetone Azine (AA) AA 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0-1 -2 Chemical Shift (ppm)
NMR Study of reaction conversion NMR of the precipitate showed mostly hydrazone, the conversion is close to100% by weight NMR of supernatant showed ~30% of unreacted sample, hydrazone and acetone azine formed due to the presence of residual hydrazine in the sample Spiking experiment showed 100.9% recovery of spiked hydrazine (synergistic effect?)
Residual Hydrazine Analysis in Neutral Molecules with Low Solubility in Acetone Procedure: - Dissolved sample (~50mg) in NMP or any other suitable solvent - Added 0.1 ml of acetone/hcooh; - Analyzed sample by the method described above The recovery of hydrazine from solution fortified with hydrazine mono-hydrate was 103%
Direct Analysis of Hydrazine in Aqeous Solutions 1000.00 Mixed-Mode Chromatography: mv 800.00 3.00 600.00 2.00 400.001.00 0.00 200.00-1.00 0.00-2.00-3.00 3.099 3.099 11.064 2.00 4.00 6.00 8.00 10.00 12.00 14.00 16.00 18.00 20.00 Minutes Column: Primesep 100 (Sielc Technology) 2.00 4.00 6.00 8.00 10.00 12.00 Gradient: 20%ACN/80%H2O/0.2%TFA for 6 min, then 14.00 16.00 18.00 20.00 80%ACN/20%H2O/0.2%TFA, 1 ml/min, Sample concentration - 31.4 mg/ml, inj. Vol.- 10 µl Detection: ELSD; T= 40 O C; Photomultiplier voltage- 500
Direct Analysis of Hydrazine by Mixed-Mode Chromatography ELSD Calibration Curve for Hydrazine Dihydrochloride CAD Calibration Curve for Hydrazine Monohydrate Y 1600000 1400000 1200000 1000000 800000 600000 400000 200000 0 y = 159952x 1.3903 R 2 = 0.9992 mg/ml 0 2 4 6 CAD peak Area 1.8E+06 1.6E+06 y = 892671x - 6081.7 R 2 = 0.9972 1.4E+06 1.2E+06 1.0E+06 8.0E+05 6.0E+05 4.0E+05 2.0E+05 0.0E+00 0 0.5 1 1.5 2 mg/ml Detection limit - ~100 ppm Detection limit - ~35 ppm
Conclusion The reaction of acetone with hydrazine free base and HCl salts has been investigated and conditions were developed for quantitative and fast conversion to acetone azine A fast and sensitive GC method for residual hydrazine analysis in pharmaceutical samples has been developed Excellent linear relationship between acetone azine concentration and FID response was demonstrated with minimal detectable concentration 0.24 ppm The method is applicable to pharmaceutical compounds at all stages of development with some modifications Hydrazine can be analyzed in aqueous solutions using mixedmode chromatography and CAD detection with minimal detectable concentration 35 ppm
Acknowledgments Su Pan (CAD data) Kana Yamamoto Reginald Cann Xinhua Qian