Page 2. What is the main purpose of the steel core? To force more current into the outer sheath.

Similar documents
Which expression gives the elastic energy stored in the stretched wire?

, causing the length to increase to l 1 R U M. L Q P l 2 l 1

X has a higher value of the Young modulus. Y has a lower maximum tensile stress than X

Which one of the following correctly describes the velocities of the two bodies after the collision?

1 (a) On the axes of Fig. 7.1, sketch a stress against strain graph for a typical ductile material. stress. strain. Fig. 7.1 [2]

22 Which of the following correctly defines the terms stress, strain and Young modulus? stress strain Young modulus

The Young modulus is defined as the ratio of tensile stress to tensile strain. Explain what is meant by each of the terms in italics.

MECHANICAL PROPERTIES OF SOLIDS

When a mass of 16 kg is suspended from the centre of AB, the bar remains horizontal.

Stress Strain Elasticity Modulus Young s Modulus Shear Modulus Bulk Modulus. Case study

Elastic Properties of Solid Materials. Notes based on those by James Irvine at

(1) Brass, an alloy of copper and zinc, consists of 70% by volume of copper and 30% by volume of zinc.

Which row, A to D, in the table correctly shows the quantities conserved in an inelastic collision? mass momentum kinetic energy total energy

9 MECHANICAL PROPERTIES OF SOLIDS

Equilibrium & Elasticity

Q16.: A 5.0 kg block is lowered with a downward acceleration of 2.8 m/s 2 by means of a rope. The force of the block on the rope is:(35 N, down)

A-level PHYSICS (7408/1)

13 Solid materials Exam practice questions

AS PHYSICS (7407/2) Paper 2. Specimen 2014 Morning Time allowed: 1 hour 30 minutes SPECIMEN MATERIAL


1 An experiment is carried out to find a value for g, the acceleration of free fall.

Statics. Phys101 Lectures 19,20. Key points: The Conditions for static equilibrium Solving statics problems Stress and strain. Ref: 9-1,2,3,4,5.

Elasticity. A PowerPoint Presentation by Paul E. Tippens, Professor of Physics Southern Polytechnic State University Modified by M.

CHAPTER 12 STATIC EQUILIBRIUM AND ELASTICITY. Conditions for static equilibrium Center of gravity (weight) Examples of static equilibrium

1. A pure shear deformation is shown. The volume is unchanged. What is the strain tensor.

MECHANICAL PROPERTIES OF SOLIDS

6.4 A cylindrical specimen of a titanium alloy having an elastic modulus of 107 GPa ( psi) and

Chapter 26 Elastic Properties of Materials

There are three main types of structure - mass, framed and shells.

D : SOLID MECHANICS. Q. 1 Q. 9 carry one mark each. Q.1 Find the force (in kn) in the member BH of the truss shown.

MECE 3321 MECHANICS OF SOLIDS CHAPTER 3

CHAPTER 3 THE EFFECTS OF FORCES ON MATERIALS

Static Equilibrium; Elasticity & Fracture

NORMAL STRESS. The simplest form of stress is normal stress/direct stress, which is the stress perpendicular to the surface on which it acts.

PMT. GCE AS and A Level. Physics A. AS exams 2009 onwards A2 exams 2010 onwards. Unit 2: Approved specimen question paper. Version 1.

Question Figure shows the strain-stress curve for a given material. What are (a) Young s modulus and (b) approximate yield strength for this material?

Springs Old Exam Questions

PHYA2. (JUN15PHYA201) WMP/Jun15/PHYA2/E4. General Certificate of Education Advanced Subsidiary Examination June Mechanics, Materials and Waves

Physics. Assignment-1(UNITS AND MEASUREMENT)


Class XI Chapter 9 Mechanical Properties of Solids Physics

Class XI Physics. Ch. 9: Mechanical Properties of solids. NCERT Solutions

Thermal physics revision questions

Mechanics of Solids. Mechanics Of Solids. Suraj kr. Ray Department of Civil Engineering

ME 243. Mechanics of Solids

PHYA2. General Certificate of Education Advanced Subsidiary Examination January Mechanics, Materials and Waves

(2) Calculate the spring constant, k, for the spring. State an appropriate unit.

Introduction to Engineering Materials ENGR2000. Dr. Coates

Figure 1. Before starting the investigation the student wrote the following prediction:

Elasticity: Term Paper. Danielle Harper. University of Central Florida

Chapter 13 ELASTIC PROPERTIES OF MATERIALS

Laser Lab Finding Young s Modulus

AP Physics 1 Waves and Simple Harmonic Motion Practice Test

Question 9.1: Answer. Length of the steel wire, L 1 = 4.7 m. Area of cross-section of the steel wire, A 1 = m 2

Lecture Presentation Chapter 8 Equilibrium and Elasticity

ELASTIC STRINGS & SPRINGS

PhysicsAndMathsTutor.com 1

Revision Guide for Chapter 4

Kinematics. v (m/s) ii. Plot the velocity as a function of time on the following graph.

1. What would be the value of F1 to balance the system if F2=20N? 20cm T =? 20kg

Physics (Specification A)

UNIVERSITY OF MALTA G.F. ABELA JUNIOR COLLEGE

Fig. 2.1 I =... A [2] Suggest why it would be impossible for overhead cables carrying an alternating current to float in the Earth s magnetic field.

Equilibrium. the linear momentum,, of the center of mass is constant

SIR MICHELANGELO REFALO CENTRE FOR FURTHER STUDIES VICTORIA GOZO

THIS IS A NEW SPECIFICATION MODIFIED LANGUAGE

The science of elasticity

ME 2570 MECHANICS OF MATERIALS

The maximum kinetic energy is directly proportional to the frequency. The time for one oscillation is directly proportional to the frequency.

Objectives: After completion of this module, you should be able to:

PHYS 101 Previous Exam Problems. Force & Motion I

UNIVERSITY OF CAMBRIDGE INTERNATIONAL EXAMINATIONS General Certificate of Education Advanced Subsidiary Level and Advanced Level

Physics *P44923A0128* Pearson Edexcel P44923A. Advanced Subsidiary Unit 1: Physics on the Go. International Advanced Level

Candidate Name Centre Number Candidate Number

Title of Lesson: Can All Things Stretch? RET Project Connection: Failure Modes of Lightweight Sandwich Structures

Physics (Specification A)

ME 207 Material Science I

University of Malta G.F. Abela Junior College

MECHANICAL PROPERTIES OF MATERIALS

Chapter 10 Lecture Outline. Copyright The McGraw-Hill Companies, Inc. Permission required for reproduction or display.


Tensile stress strain curves for different materials. Shows in figure below

Thermal physics revision questions

MEI Mechanics 1. Applying Newton s second law along a line

AP Physics Free Response Practice Oscillations

SOLUTION a. Since the applied force is equal to the person s weight, the spring constant is 670 N m ( )( )

INTRODUCTION TO STRAIN

FIGURE P13.5 FIGURE P13.6. Chapter 13 Problems

Young s modulus. W.E. Bailey, APAM/MSE EN1102

Chapter 5 Elastic Strain, Deflection, and Stability 1. Elastic Stress-Strain Relationship

cos(θ)sin(θ) Alternative Exercise Correct Correct θ = 0 skiladæmi 10 Part A Part B Part C Due: 11:59pm on Wednesday, November 11, 2015

Sean Carey Tafe No Lab Report: Hounsfield Tension Test

MECHANICAL PROPERTIES OF SOLIDS

OCR Physics Specification A - H156/H556

UNIT I SIMPLE STRESSES AND STRAINS

TOPIC B: MOMENTUM EXAMPLES SPRING 2019

STATICALLY INDETERMINATE STRUCTURES

PHYA2. General Certificate of Education Advanced Subsidiary Examination January Mechanics, Materials and Waves. (JAN13PHYA201) WMP/Jan13/PHYA2

SF016: PAST YEAR PSPM QUESTIONS

Announcements. Suppose your scores are 12, 16, 15. (16/20)*20 + (15/20)*15 + (12/20)*15 = out of a possible

Transcription:

Q1.The overhead cables used to transmit electrical power by the National Grid usually consist of a central core of steel cables surrounded by a sheath of cables of low resistivity material, such as aluminium. What is the main purpose of the steel core? D To force more current into the outer sheath. To provide additional current paths through the cables. To reduce the power lost from the cables. To increase the mechanical strength of the cables. Page 2

Q2. load of 3.0 N is attached to a spring of negligible mass and spring constant 15 N m 1. What is the energy stored in the spring? 0.3 J 0.6 J 0.9 J D 1.2 J Page 3

Q3.The diagram shows how the stress varies with strain for metal specimens X and Y which are different. oth specimens were stretched until they broke. Which of the following is incorrect? X is stiffer than Y X has a higher value of the Young modulus X is more brittle than Y D Y has a lower maximum tensile stress than X Page 4

Q4.Two vertical copper wires X and Y of equal length are joined as shown. Y has a greater diameter than X. weight W is hung from the lower end of Y. Which of the following is correct? The strain in X is the same as that in Y. The stress in Y is greater than that in X. The tension in Y is the same as that in X. D The elastic energy stored in X is less than that stored in Y. Page 5

Q5.Two masses hang at rest from a spring, as shown in the diagram. The string separating the masses is burned through. Which of the following gives the accelerations of the two masses as the string breaks? acceleration of free fall = g acceleration of 1 kg mass upwards in m s 2 acceleration of 2 kg mass downwards in m s 2 3 g 1 g 2 g 2 g 2 g 1 g D 1 g 1 g Page 6

Q6.The four bars,, and D have diameters, lengths and loads as shown. They are all made of the same material. Which bar has the greatest extension? Q7.For which of the following relationships is the quantity y related to the quantity x by the relationship x y energy stored in a spring extension of the spring gravitational field strength distance from a point mass de roglie wavelength of an electron momentum of the electron D period of a mass-spring system spring constant (stiffness) of the spring Page 7

Q8. load of 4.0 N is suspended from a parallel two-spring system as shown in the diagram. The spring constant of each spring is 20 N m 1. The elastic energy, in J, stored in the system is 0.1 0.2 0.4 D 0.8 Page 8

Q9.The graph shows the variation of stress with strain for a ductile alloy when a specimen is slowly stret hed to a a i u strai of ε m and the stress is then slowly reduced to zero. The shaded area represents the work done per unit volume when stretching the specimen represents the energy per unit volume recovered when the stress is removed represents the energy per unit volume which cannot be recovered D has units of J m 1 Page 9

Q10.The force on a sample of a material is gradually increased and then decreased. The graph of force against extension is shown in the diagram. The increase in thermal energy in the sample is represented by area D R P + Q P + Q + R P + Q R Q11. stone is projected horizontally by a catapult consisting of two rubber cords. The cords, which o e Hooke s law, are stret hed a d released. Whe ea h ord is e te ded x, the stone is projected with a speed v. ssuming that all the strain energy in the rubber is transferred to the stone, what is the speed of the stone when each cord is extended by 2x? v D 2v 4v Page 10

Page 11