SITE SELECTION CRITERIA FOR A SOLAR PV PLANT. Under The Guidence of SOHEL PATEL

Transcription

1 SITE SELECTION CRITERIA FOR A SOLAR PV PLANT Under The Guidence of SOHEL PATEL

2 CONTENTS Introduction Selection of land 1.area longitude & latitude 2.quality of soil 3.soil test report 4.Terrain & contours of land Land & weather contours 1.solar insolation and shadow assessment 2.Wind 3.climate 4.temperature 5.rainfall Water availability Electrical switch yard & loading criteria Transportation & Manpower availability

3 Introduction Choosing the right solar module support method involves understanding a variety of environmental factors such as soil conditions, geographic location, and regional wind speeds to name a few. Other important factors that need to be considered include soil mechanics such as consolidation, permeability and seepage, bearing capacity, lateral earth pressure, slope stability, as well as wind engineering to determine potential forces or loads that the solar module installation will be subject to, based on panel size, panel weight, geographic orientation, etc. Each of these factors needs to be carefully considered for each and every solar system installation in order to minimize the risk of downtime caused by damage or failure to the system components and then in turn maximize the ROI or return on investment of the system.

4 Cont Everyday there is a likelihood that solar modules are being installed somewhere in India without giving the proper consideration to the environmental and engineering factors related to the project. This is a failure waiting to happen. The right rain conditions, the right wind conditions, equal the wrong outcome.

5 Cont When employing driven piles, screw augers, or concrete piers, it is essential to consider all of the environmental factors involved to reduce the risk of hole widening or pole tilting due to ground consolidation, panel rotation due to wind forces, soil saturation, lateral earth pressure, etc. which can directly affect the orientation and therefore the efficiency of the panels, and which can also cause damage to the electrical connections below ground requiring costly repair. When utilizing precast ballasted footings or ballasted trays it is imperative to understand wind loads, slope stability, soil permeability and seepage, etc, to know how wind loads can cause overturning or sliding.

6

7 For installing 1MW PV plant 5 acres of land is required. Here we have selected a land located 5 km away from the Bhongir town, Hyderabad Telangana which comes under Deccan plateau. It has an average elevation 329 m / 1079 ft above sea level. Area 5 acres Location Bhongir Latitude of Area :17.5 N Longitude of Area :78.89 E

8 Tilt Angle: To maximize the output of the solar power system, especially in PV Solar Array applications, the optimal tilt angle is typically specified for non tracking systems, and remains fixed. Structurally, higher tilt angles result in an increased wind load on the solar module which would require a larger ballasted footing. In addition, higher tilt angles may require an increase in distance between rows to eliminate adjacent row over shading.

9 A lower tilt angle is often desired to minimize the wind forces and reduce the ballasted footing size. This may not be feasible in areas of substantial snowfall where an increased tilt angle may be required to shed snow off of the solar module effectively. A lower tilt angle also results in reduced adjacent row over shading potential which allows the module rows to be spaced closer together. A cost comparison could be done to compare the tilt angle versus the adjacent row over shading versus the ballasted footing size. In addition, lower tilt angles allow for more compact utilization of the land available by minimizing the unusable area that is in shade thus offering an opportunity for more solar modules.

10 This area comprises or consists of red soil/loamy to clayey deep reddish brown soil. In this area the soil strength is moderate and light weighed. The moisture content is low to moderate level during pre monsoon and medium during post monsoon. In average the soil is a bit dusty on the upper most layer all over the year.

11 Colour of land - Yellowish/ Ash colour Land characteristics type - light weight land Ph of land medium Salinity of land Availability of minerals in land Nitrogen - 95kg/ Acre Phosphorus kg/ Acre Potash kg/ Acre

12 As we have already mention that this area comes under deccan plateau so, the level of the land is neither flat nor sloppy. It is a rocky land. The surface is covered with small sized rocks which occupies 0.5 to 1sqm area in average.

13

14 Solar radiation assessment is a critical activity for setting up Solar projects. The quality of the resource also impacts the type of technology which may be used at a specific place for solar power generation. A micro level of assessment is required at this stage. This activity shall assess solar resource attractiveness of the proposed site. The Horizontal Daily solar radiation of our proposed site is 5.18 kwh per day The detailed average annual insolation is shown below in table 1

15

16 2.Wind In the chosen area the wind flow is moderate and it will be same through out the year and the effect of wind is very less because the site where the 1Mw plant to be installed is come under Deccan plateau only during monsoon the wind speed is more which ranges up to 6.30 Km per hour in June Wind speed: km/sec Wind direction- south east & south east south The detailed average annual wind speed is shown below in table 1

17

18 The region experiences hot and dry summer throughout the year except during the South West Monsoon season. The year may broadly be divided into four seasons. It experiences cold season from December to Mid February, summer season from Mid February to first week of June. South West monsoon season from June to September and retreating monsoon or the past monsoon season during October to November. Meteorological drought vulnerability 26% which is moderate according to average Indian drought frequency.

19 4.Temperature Cold season extending from December to February is followed by summer when both day and night temperatures increase sharply. May being the hottest month, the mean daily maximum temperature is about 40*C (104.0*F) and the mean daily minimum is about 28*C (82.4*F) sometimes the day temperature crosses 44*C during this period. On some days, afternoon thundershowers come as a blessing and though temporarily they bring relief from the oppressive summer heat. By about the beginning of October day temperature decreases steadily signaling the withdrawal of monsoon. Day and night temperature decrease rapidly during November. December is the coldest month with the mean daily maximum and minimum temperatures being 35*C and 20*C respectively. Sometimes during the cold season, night temperature may drop down to about 10*C..

20 The skies are generally clear or lightly clouded throughout the year except during south west monsoon season when heavy clouds cast the skies. Avg. of Annual air wether temperature: 27 C Earth temperature: 30.2 C Atmospheric pressure: 96.3KPa The detailed average annual weather is shown below in table 1

21 The average rainfall in the site is 772 mm. 71% of the annual rainfall is received by the district during south west monsoon (i.e. June to September). September is the rainiest month. During summer and retreating monsoon season some amount of rainfall is received in the form of thunder showers. The variation in the annual rainfall in the district from year to year is large. On an average there are 46 rainy days. (i.e days with rainfall of over 2.5mm or more).

22

23

24

25 The crystalline rocks inherently devoid of primary porosity, however, subsequently, with dynamic process of weathering, the rocks undergo fracturing and fissuring and joints over a period of time, lead to the development of secondary porosity, which forms the repository for ground water. The ground water occurs under water table conditions in weathered zone and semiconfined and confined conditions in fractured zone.

26 The phreatic aquifer is developed by means of open dug wells with depth ranging from 6-15 m and dug-cum-bore wells up to 60m. The yield of irrigation wells range from 100 to 150 cu.m/day. At places, it is upto 200 cu.m/day. Water available in pre monsoon- 5 to 26 meter below ground level Water available in post monsoon- 2 to meter below ground level

27 The small scale projects are to be connected at 33/11 KV substation on 33 KV side. A substation can have maximum of one small scale solar PV project. We need to undertake evacuation feasibility assessment starting from the nearest 33/11 KV sub-station and map the availability and capacity of the evacuation infrastructure. This feasibility identifies the: Nearest substation for power evacuation Evacuation capacity of the sub-station- to be checked with distribution utility The receiving end sub-station is 1.5km distance away from our 1 MW solar PV site. The receiving end substation's capacity is 33/11 KV which comes under TSSPDCL.

28 Electrical switch yard

29 The proposed site Bhongir for 1MW PV plant installation is located nearer to the Hyderabad Capital of Telangana which is 45km far from the choosen and the road way transport is quite developed and it is very feasible for the transportation of the solar power plant equipments with out any kind of transport delay According to our survey there is surplus man power available for the civil work and installation of the plant nearer to the selected area so there will be less chances of obstacles or time delay in the progress of setting up solar power plant in Bhongir.

30