TC74VHC573F,TC74VHC573FW,TC74VHC573FT,TC74VHC573FK

Size: px

Start display at page:

Download "TC74VHC573F,TC74VHC573FW,TC74VHC573FT,TC74VHC573FK"

Phillip Clark
5 years ago
Views:

1 TOSHIBA CMOS igital Integrated Circuit Silicon Monolithic TC74VHC573F/FW/FT/FK TC74VHC573F,TC74VHC573FW,TC74VHC573FT,TC74VHC573FK Octal -Type Latch with 3-State Output The TC74VHC573 is an advanced high speed CMOS OCTAL LATCH with 3-STATE OUTPUT fabricated with silicon gate C2MOS technology. It achieves the high speed operation similar to equivalent Bipolar Schottky TTL while maintaining the CMOS low power dissipation. This 8-bit -type latch is controlled by a latch enable input (LE) and a output enable input ( OE ). When the OE input is high, the eight outputs are in a high impedance state. An input protection circuit eures that 0 to 5.5 V can be applied to the input pi without regard to the supply voltage. This device can be used to interface 5 V to 3 V systems and two supply systems such as battery back up. This circuit prevents device destruction due to mismatched supply and input voltages. Note: xxxfw (JEEC SOP) is not available in Japan. TC74VHC573F Features High speed: tpd = 4.5 (typ.) at VCC = 5 V Low power dissipation: ICC = 4 µa (max) at Ta = 25 C High noise immunity: VNIH = VNIL = 28% VCC (min) Power down protection is provided on all inputs. Balanced propagation delays: tplh tphl Wide operating voltage range: VCC (opr) = 2 to 5.5 V Low noise: VOLP = 1.2 V (max) Pin and function compatible with 74ALS573 TC74VHC573FW TC74VHC573FT TC74VHC573FK Weight SOP20-P A : 0.22 g (typ.) SOP20-P : 0.22 g (typ.) SOL20-P : 0.46 g (typ.) TSSOP20-P A : 0.08 g (typ.) VSSOP20-P : 0.03 g (typ.) 1

2 Pin Assignment IEC Logic Symbol OE V CC Q0 OE LE (1) (11) EN C Q1 Q2 Q3 Q4 Q (2) (3) (4) (5) (6) (7) (8) (9) 1 (19) (18) (17) (16) (15) (14) (13) (12) Q0 Q1 Q2 Q3 Q4 Q5 Q6 Q Q Q7 GN LE (top view) Truth Table Inputs OE LE Output H X X Z L L X Q n L H L L L H H H X: on t care Z: High impedance Q n : Q outputs are latched at the time when the LE input is taken to a low logic level. System iagram LE 11 OE Q0 Q1 Q2 Q3 Q4 Q5 Q6 Q7 2

3 Absolute Maximum Ratings (Note) Characteristics Symbol Rating Unit Supply voltage range V CC 0.5 to 7.0 V C input voltage V IN 0.5 to 7.0 V C output voltage V OUT 0.5 to V CC V Input diode current I IK 20 ma Output diode current I OK ±20 ma C output current I OUT ±25 ma C V CC /ground current I CC ±75 ma Power dissipation P 180 mw Storage temperature T stg 65 to 150 C Note: Exceeding any of the absolute maximum ratings, even briefly, lead to deterioration in IC performance or even destruction. Recommended Operating Conditio (Note) Characteristics Symbol Rating Unit Supply voltage V CC 2.0 to 5.5 V Input voltage V IN 0 to 5.5 V Output voltage V OUT 0 to V CC V Operating temperature T opr 40 to 85 C Input rise and fall time dt/dv 0 to 100 (V CC = 3.3 ± 0.3 V) 0 to 20 (V CC = 5 ± 0.5 V) /V Note: The recommended operating conditio are required to eure the normal operation of the device. Unused inputs must be tied to either VCC or GN. 3

4 Electrical Characteristics C Characteristics Characteristics Symbol Test Condition Ta = 25 C Ta = 40 to 85 C V CC (V) Min Typ. Max Min Max Unit High-level input voltage V IH to V CC V CC 0.7 V Low-level input voltage V IL to V CC V CC 0.3 V High-level output voltage V OH V IN = V IH or V IL I OH = 50 µa I OH = 4 ma V I OH = 8 ma Low-level output voltage V OL V IN = V IH or V IL I OL = 50 µa I OL = 4 ma V I OL = 8 ma state output off-state current I OZ V IN = V IH or V IL V OUT = V CC or GN 5.5 ±0.25 ±2.50 µa Input leakage current Quiescent supply current I IN V IN = 5.5 V or GN 0 to 5.5 ±0.1 ±1.0 µa I CC V IN = V CC or GN µa Timing Requirements (input: t r = t f = 3 ) Characteristics Symbol Test Condition Ta = 25 C Ta = 40 to 85 C V CC (V) Typ. Limit Limit Unit Minimum pulse width (LE) t w (H) 3.3 ± ± Minimum set-up time t s 3.3 ± ± Minimum hold time t h 3.3 ± ±

5 AC Characteristics (input: t r = t f = 3 ) Characteristics Symbol Test Condition Ta = 25 C Ta = 40 to 85 C V CC (V) C L (pf) Min Typ. Max Min Max Unit Propagation delay time (LE-Q) Propagation delay time (-Q) 3-state output enable time 3-state output disable time Output to output skew t plh t phl t plh t phl t pzl t pzh t plz t phz t oslh t oshl R L = 1 kω R L = 1 kω (Note 1) 3.3 ± ± ± ± ± ± ± ± ± ± Input capacitance C IN pf Output capacitance C OUT 6 pf Power dissipation capacitance Note 1: Parameter guaranteed by design. C P (Note 2) 29 pf t oslh = t plhm t plhn, t oshl = t phlm t phln Note 2: C P is defined as the value of the internal equivalent capacitance which is calculated from the operating current coumption without load. Average operating current can be obtained by the equation: I CC (opr) = C P V CC f IN + I CC /8 (per latch) And the total C P when n pcs. of latch operate can be gained by the following equation: C P (total) = n 5

6 Noise Characteristics (input: t r = t f = 3 ) (Note) Characteristics Symbol Test Condition Ta = 25 C V CC (V) Typ. Max Unit Quiet output maximum dynamic V OL Quiet output minimum dynamic V OL Minimum high level dynamic input voltage Maximum low level dynamic input voltage V OLP C L = 50 pf (0.9) 1.0 (1.2) V V OLV C L = 50 pf V ( 0.9) ( 1.2) V IH C L = 50 pf V V IL C L = 50 pf V Note: The value in ( ) only applies to JEEC SOP (FW) devices. Input Equivalent Circuit INPUT 6

7 Package imeio Weight: 0.22 g (typ.) 7

8 Package imeio Weight: 0.22 g (typ.) 8

9 Package imeio (Note) Note: This package is not available in Japan. Weight: 0.46 g (typ.) 9

10 Package imeio Weight: 0.08 g (typ.) 10

11 Package imeio Weight: 0.03 g (typ.) 11

12 Note: Lead (Pb)-Free Packages SOP20-P A TSSOP20-P A VSSOP20-P RESTRICTIONS ON PROUCT USE EBA The information contained herein is subject to change without notice _ TOSHIBA is continually working to improve the quality and reliability of its products. Nevertheless, semiconductor devices in general can malfunction or fail due to their inherent electrical seitivity and vulnerability to physical stress. It is the respoibility of the buyer, when utilizing TOSHIBA products, to comply with the standards of safety in making a safe design for the entire system, and to avoid situatio in which a malfunction or failure of such TOSHIBA products could cause loss of human life, bodily injury or damage to property. In developing your desig, please eure that TOSHIBA products are used within specified operating ranges as set forth in the most recent TOSHIBA products specificatio. Also, please keep in mind the precautio and conditio set forth in the Handling Guide for Semiconductor evices, or TOSHIBA Semiconductor Reliability Handbook etc _A The TOSHIBA products listed in this document are intended for usage in general electronics applicatio (computer, personal equipment, office equipment, measuring equipment, industrial robotics, domestic appliances, etc.). These TOSHIBA products are neither intended nor warranted for usage in equipment that requires extraordinarily high quality and/or reliability or a malfunction or failure of which may cause loss of human life or bodily injury ( Unintended Usage ). Unintended Usage include atomic energy control itruments, airplane or spaceship itruments, traportation itruments, traffic signal itruments, combustion control itruments, medical itruments, all types of safety devices, etc. Unintended Usage of TOSHIBA products listed in this document shall be made at the customer s own risk _B The products described in this document shall not be used or embedded to any dowtream products of which manufacture, use and/or sale are prohibited under any applicable laws and regulatio _Q The information contained herein is presented only as a guide for the applicatio of our products. No respoibility is assumed by TOSHIBA for any infringements of patents or other rights of the third parties which may result from its use. No licee is granted by implication or otherwise under any patent or patent rights of TOSHIBA or others _C The products described in this document are subject to the foreign exchange and foreign trade laws _E 12

TC74VHC574F,TC74VHC574FW,TC74VHC574FT,TC74VHC574FK

TOSHIBA CMOS igital Integrated Circuit Silicon Monolithic TC74VHC574F/FW/FT/FK TC74VHC574F,TC74VHC574FW,TC74VHC574FT,TC74VHC574FK Octal -Type Flip Flop with 3-State Output The TC74VHC574 is advanced high