GB/T / IEC 62321:2008

Transcription

1 Translated English of Chinese Standard: GB/T ICS L 10 NATIONAL STANDARD OF THE PEOPLE S REPUBLIC OF CHINA GB GB/T / IEC 62321:2008 Electrical and electronic products Determination of six regulated substances (lead, mercury, cadmium, hexavalent chromium, polybrominated biphenyl, polybrominated diphenyl ethers) 电子电气产品六种限用物质 ( 铅 汞 镉 六价铬 多溴联苯和多溴二苯醚 ) 的测定 (IEC 62321:2008, Electrotechnical products - Determination of levels of six regulated substances (lead, mercury, cadmium, hexavalent chromium, polybrominated biphenyls, polybrominated diphenyl ethers, IDT) Issued on: May 12, 2011 Implemented on: August 1, 2011 Issued by: General Administration of Quality Supervision, Inspection and Quarantine of the People's Republic of China; Standardization Administration of the People's Republic of China. Page 1 of 122

2 Table of Contents Foreword... 6 Introduction Scope Normative references Terms, definitions and abbreviations Terms and definitions Abbreviations Test methods Overview Field of application Sample Test methods Flow chart Adjustment to the matrix Limits of detection (LOD) and limits of quantification (LOQ) Test report Alternative test methods Mechanical sample preparation Overview Apparatus, equipment and materials Procedure Screening by X-ray fluorescence spectrometry (XRF) Overview Apparatus, equipment and materials Reagents Sampling Procedure Calculations Evaluation of the method Quality control Special cases Determination of mercury in polymers, metals and electronics by CV- AAS, CV-AFS, ICP- OES and ICP-MS Overview Apparatus, equipment and materials Reagents Sample preparation Page 2 of 122

3 7.5 Test procedure Evaluation of the method Determination of lead and cadmium in polymers by ICP-OES, ICP-MS and AAS Overview Apparatus, equipment and materials Reagents Sample preparation Test procedure Evaluation of the method Determination of lead and cadmium in metals by ICP-OES, ICP-MS and AAS Overview Apparatus, equipment and materials Reagents Sample preparation Preparation of laboratory reagent blank Test procedure Evaluation of the method Determination of lead and cadmium in electronics by ICP-OES, ICP-MS and AAS Overview Apparatus, equipment and materials Reagents Sample preparation Test procedure Evaluation of the method Appendix A A.1 Introductory remark A.2 Apparatus, equipment and materials A.3 Reagents A.4 General instructions for the analysis A.5 Sample preparation A.6 Calibration A.7 GC-MS A.8 Quality control A.9 Evaluation of the method A.10 PBB and PBDE calibrants A.11 Alternative extraction procedures for soluble polymers Page 3 of 122

4 A.12 Examples of chromatograms at suggested GC-MS conditions Appendix B B.1 Overview B.2 Apparatus, equipment and materials B.3 Reagents B.4 Sample preparation B.5 Test procedures B.6 Evaluation of the method Appendix C C.1 Overview C.2 Apparatus, equipment and materials C.3 Reagents C.4 Sample preparation C.5 Test procedure C.6 Determination of method detection limit and limit of quantification C.7 Evaluation of the method Annex D D.1 Introductory remark D.2 Matrix and interference effects D.3 Interpretation of results D.4 Summary results of the IIS2 as related to the XRF method Annex E E.1 Equipment E.2 Instrument parameters Annex F F.1 ICP-OES F.2 ICP-MS F.3 AAS Annex G G.1 ICP-OES G.2 Background correction G.3 ICP-MS G.4 AAS Annex H H.1 Program for microwave digestion H.2 ICP-OES Page 4 of 122

5 H.3 Background correction H.4 ICP-MS H.5 AAS Bibliography Page 5 of 122

6 Foreword This Standard is formulated in accordance with the rules in GB/T This Standard uses translation method to equivalently adopt IEC 62321:2008 Electrotechnical products - Determination of six regulated substances (Lead, mercury, cadmium, hexavalent chromium, polybrominated biphenyl, polybrominated diphenyl ethers). This Standard makes the following editorial changes: - In order to be consistent with our existing national standard series, the standard name is changed to "Electrical and electronic products - Determination of six regulated substances (Lead, mercury, cadmium, hexavalent chromium, polybrominated biphenyl, polybrominated diphenyl ethers)"; - According to the latest development of international standards, the IEC/PAS document that was not explicitly specified in NOTE 1 of Clause 1 of the original text is clearly changed to IEC/PAS 62596:2009; add a reference document IEC/PAS 62596:2009 in Normative Reference; - According to the latest development of international standards, the reference document IEC/TS in NOTE 2 of the original text is changed to IEC/TR 62476:2009; - For the convenience of users to understand and use of the standard, add NOTE to "trace metals" grade. Our national documents that are corresponding to the international documents quoted in the Normative References of this Standard are as follows: - GB/T Water for analytical laboratory use. Specification and test methods (ISO 3696:1987, MOD). This Standard shall be under the jurisdiction of the China Electrical & Electronics Products and Systems, Environmental Standardization Technical Committee (SAC/TC297). Drafting organizations of this Standard: China Electronics Standardization Institute, 5 th Electronic Institute of Ministry of Industry and Information Technology, Ningbo Entry-Exit Inspection and Quarantine Bureau, Jiangsu Entry-Exit Inspection and Quarantine Bureau, Shenzhen Academy of Metrology and Quality Inspection, Shenzhen Entry-Exit Inspection and Quarantine Bureau, Guangdong Entry-Exit Inspection and Quarantine Bureau, and Carolina Technology (Beijing) Limited. Main drafters of this Standard: Xing Weibing, Luo Daojun, Chen Jianguo, He Zhonghui, Chen Zeyong, Liu Zhihong, Zhou Minghui, Yang Lifeng, Dong Juan. Page 6 of 122

7 Electrical and electronic products Determination of six regulated substances (lead, mercury, cadmium, hexavalent chromium, polybrominated biphenyl, polybrominated diphenyl ethers) 1 Scope This Standard specifies the determination of the levels of lead (Pb), mercury (Hg), cadmium (Cd), hexavalent chromium (Cr(VI)), and two types of brominated flame retardants - polybrominated biphenyls (PBB) and polybrominated diphenyl ethers (PBDE) that are contained in electrical and electronic products. This Standard refers to the sample as the object to be processed and measured. The nature of the sample and the manner in which it is acquired is defined by the entity carrying out the tests. NOTE 1: Further guidance on obtaining representative samples from finished electronic products to be tested for levels of regulated substances may be found in the future IEC/PAS 62596:2009. [1] It is noted that the selection of the sample may affect the interpretation of the test results. This Standard does not determine: - the definition of a unit or homogenous material as the sample; - the disassembly procedure employed for obtaining a sample; - assessment procedures. NOTE 2: Further guidance on assessment procedures may be found in IEC/TR 62476:2009. [2] 2 Normative references The following referenced documents are indispensable for the application of this Standard. For dated documents, only the specific edition apply. For undated references, the latest edition of the referenced document (including any amendments) applies. GB/T General requirements for the competence of testing and calibration laboratories (GB/T , ISO/IEC 17025:2005, IDT) ISO/IEC Guide 98:1995 Guide to the expression of uncertainty in measurement ISO 3696 Water for analytical laboratory use Specification and test methods ISO 5961 Water quality Determination of cadmium by atomic absorption spectrometry 3 Terms, definitions and abbreviations 3.1 Terms and definitions Page 8 of 122

8 bis(pentabromophenyl) ether EINECS No or CAS No ; Cr(VI) [48] ISO 3613 Chromate conversion coatings on zinc, cadmium, aluminium-zinc alloys and zincaluminium alloys Test methods [49] DIN Determination of hexavalent chromium in corrosion protection coatings Part 1: Qualitative analysis [50] EN 15205:2006 Determination of hexavalent chromium in corrosion protection layers. Qualitative analysis [51] GMW3034 Absence of Hexavalent Chrome (VI) Coatings [52] U.S. Department of Health and Human Services Agency for Toxic Substances and Disease Registry, Toxicological Profile for Chromium. April, 1993 [53] United States Environmental Protection Agency (EPA), EPA method 3060A, Alkaline Digestion for Hexavalent Chromium, December 1996 [54] United States Environmental Protection Agency (EPA), EPA method 7196A, Chromium, Hexavalent (colorimetric), July 1992 [55] ZVO-0102-QUA-02 Qualitative Analysis of Cr-VI in Passivation Layers on Parts by Spot Analysis END Page 122 of 122