Supporting Information

Transcription

1 Supporting Information Interaction effects of mesoporous silica nanoparticles with different morphologies on human red blood cells Madhura Joglekar, Robert A. Roggers, Yannan Zhao, and Brian G. Trewyn * *Address correspondence to: btrewyn@mines.edu a b c d Figure S1: Transmission electron microscope (TEM) images of LS-, SS-, (c) LT- and (d) ST-MSN materials. The 2D hexagonal pore structure is visible in all the micrographs

2 Figure S2: Thermogravimetric analysis (TGA) of calcined MSN and FITC labeled MSN. The amount of FITC was quantified as 0.10 to 0.22 mmol g -1. The black, red, green and blue lines correspond to LS-, SS-, LT- and ST-MSN materials, respectively. a b c d e f g h Figure S3: X-ray diffraction (XRD) patterns of calcined LS, SS, (c) LT and (d) ST MSN materials exhibiting the characteristic 100, 110, 200 peaks. Unresolved 110 and 200 peaks are seen in Figure 2a due to short range ordering. Figures (e), (f), (g), and (h) show the dynamic light scattering data at 25 C of LS-, SS-, LT- and ST-MSN, respectively. The hydrodynamic size distribution patterns were measured at concentration of 100 µg ml -1 in PBS

3 Volume Adsorbed (cm 3 /g) Volume Adsorbed (cm 3 /g) Relative Pressure (P/P0) (c) Pore Volume (cm 3 /g-nm) Pore Diameter (nm) Relative Pressure (P/P0) Pore Volume (cm 3 /g-nm) Pore Diameter (nm) Volume Adsorbed (cm 3 /g) Volume Adsorbed (cm 3 /g) Relative Pressure (P/P0) (d) Pore Volume (cm 3 /g-nm) Pore Diameter (nm) Pore Diameter (nm) Relative Pressure (P/P0) Pore Volume (cm 3 /g-nm) Figure S4: Nitrogen sorption isotherms and pore size distributions (insets) of LS-, SS-, (c) LT- and (d) ST-MSN materials. The BET surface areas of LS-, SS-, LT-, & ST- MSN materials were calculated as ± 9.3, ± 24.9 m 2 g -1, ± 28.9 m 2 g -1 and ± 49.6 m 2 g -1. (c) Figure S5: The sample tubes are arranged in the following order in all the images: positive control (water), negative control (PBS), RBCs incubated with LS-, SS-, LT- and ST-MSN materials for 2 h at room temperature at concentrations of 20, 50, and (c) 100 µg ml

4 (c) (d) Figure S6: Hemolysis assay of human RBCs incubated for 2 h at room temperature with LS-, SS-, (c) LT-, (d) ST-MSN materials at concentrations 100 µg ml -1 (green), 250 µg ml -1 (red) and 500 µg ml -1 (blue). Water (pink) was used as positive control while PBS (black) was used as negative control and the absorbance of the supernatant was recorded at 541 nm. In, only red line is visible due to the overlap of green and blue line data with the red line data

5 (c) (c) (d) (d) Figure S7: Hemolysis assay of human RBCs incubated for 8 h at room temperature with LS-, SS-, (c) LT-, (d) ST-MSN materials at concentrations 20 µg ml -1 (green), 50 µg ml -1 (red) and 100 µg ml -1 (blue). Water (pink) was used as positive control while PBS (black) was used as negative control and the absorbance of the supernatant was recorded at 541 nm

6 i ii Figure S8: Flow cytometry analysis of PKH26 labeled RBCs (5 x 10 6 cells ml -1 ) incubated at room temperature for 2 h with FITC labeled LS-, SS-, LT- and ST-MSN materials at 10 µg ml -1. Dot plots from flow cytometry showing FITC labeled MSN particles on Y- axis and PKH26 labeled RBCs on X- axis. The plots were gated to show labeled RBCs in area Q4 and FITC associated red fluorescent dye labeled cells in area Q2. The plots correspond to RBCs incubated with (i) LS- (ii) SS- (iii) LT- and (iv) ST- MSN materials to make the final concentration 10 µg ml -1. iii iv Figure S9. A series of images of RBCs incubated with ST-MSN materials. The corresponding micrographs were taken by changing the focal plane every 0.5 µm at different z-positions

7 (c) (d) Figure S10: Scanning electron micrographs (SEM) of RBCs incubated for 2 h at room temperature with 20 µg ml -1 of LS-, SS-, (c) LT- and (d) ST-MSN materials. The images increase in magnification from top to bottom. No spiculation of RBCs is seen at 20 µg ml -1. They tend to maintain their normal discoid shape

8 a b c d Figure S11: Scanning electron micrographs of human RBCs incubated for 2 h at room temperature with 100 µg ml -1 of LS-, SS-, (c) LT- and (d) ST-MSN materials. The images increase in magnification from top to bottom. Less than 1% spiculation of RBCs was observed at 100 µg ml